enable-diffserv

Syntax

• default enable-diffserv

• default enable-diffserv enable

• default enable-diffserv port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

• default enable-diffserv port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} enable

• enable-diffserv

• enable-diffserv enable

• enable-diffserv port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

• enable-diffserv port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} enable

• no enable-diffserv

• no enable-diffserv enable

• no enable-diffserv port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

• no enable-diffserv port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} enable

Command Parameters

enable

Enables DiffServ for the specified port. The default is enabled.

port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Identifies the slot and port in one of the following formats:

• a single slot and port (slot/port)

• a range of slots and ports (slot/port-slot/port)

• a series of slots and ports (slot/port,slot/port,slot/port)

• all ports on the same slot (slot/all)

• all ports on the switch (all)

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

Default

None

Command Mode

GigabitEthernet Interface Configuration